Gini all-electric crank aerial work platform Genie® Z™-60/37DC Now it has achieved mass production in Terex Changzhou factory.。This electric drive device has been manufactured in Redmond, Washington, USA.。With the environmental protection and energy saving of large construction sites,，Multifunctional devices are in increasing demand，It has comprehensively promoted the rapid development of electric drive high-altitude vehicles in the Chinese market.。Z -60/37DC Localized manufacturing deepens the strategic layout of Gini's electric equipment products in the Chinese market，Products that can bring higher value to Chinese customers，Faster equipment delivery and easier service support，Increase the overall return on investment of the renter。

Device parameters

Platform height	18 meters
Extend horizontally	11.15 meters
Spanning height	7.4 meters
Platform load	227 kg
Equipment weight	7,530 kg

Environmentally friendly, quiet and powerful

All-new all-electric Z-60/37DCThe crank-type aerial work platform uses Gini's latest electric drive system.，It combines the advantages of environmental protection and silence with the four-wheel drive performance of traditional diesel power equipment.，Just one charge，It can carry out all-weather construction operations in indoor and outdoor construction sites.。

Genie Z-60/37DCPlatform height is 18m，Extend horizontally 11.15 meters，Spanning height 7.4 meters。Equipped with a short swivel arm with a range of motion from up to 70°To Down 65°，Platform can achieve 160°Rotation，Flexibility for the operator to reach the required work point。This brand new device has 1..8 m and 2.Two 4-meter platforms to choose from，Load 227 kg，It can carry two operators at the same time.。Standard with side swing door and front sliding bar door， 2.The 4-meter platform also has another lateral sliding bar door attached.，It is a three-entry platform。

 

Leading performance and outstanding performance

Another advantage of this device is that it is equipped withGenie FastMast™System，The operator only needs to operate one arm，It can be quickly lowered to the ground from the full height position，This design can be used when the second section of the arm is fully extended，Make the platform reach the ground directly from the highest position quickly，From the ground directly back to the highest position.。For operators who need to move working materials up and down frequently，And greatly improve that work efficiency.。In additionGenie Z-60/37DC Double parallelogram design is adopted for electric crank-type aerial work platform，Only need to lift the second section of arm to move vertically up and down along the working point.。

Genie Z-60/37DCThe electric crank-type aerial work platform adopts four-wheel drive design.，The performance is very strong。The hermetically sealed AC travel motor allows the unit to operate even when immersed in water up to 91 cm deep，It is still 25% faster than diesel-powered equipment%，The gradeability is also better than that of the traditional diesel engine.。Brand newGenie Z-60/37DCAerial work platforms are equipped with andGenie Z-62/40 andS™-60 Series Similar Swing Shaft System。At the same time，Equipped with off-road non-marking tires as standard，Not only suitable for indoor、Different application environments outdoors，Its flexible lifting capacity and flexible and convenient applicability make it the first to arrive at the site and the last to leave the site.。

 

Compact structure and convenient transportation

Compared with other types of electric aerial work platforms on the market,，Genie Z-60/37DCMore compact in design structure，Functions are also more diverse.。When the arm is raised，Its narrow footprint is combined with the advantage of a tail swing of only 58 cm.，It can be applied to most construction sites with limited space.。As light as 7,The weight of the whole machine is 530 kilograms and the length of the retraction is only 8 meters.，It is also easy to ship on a standard truck，The operation is simple and stable。